Outdoor Water Solutions WTW0114 Installation Guide download pdf (Page 15)

www.outdoorwatersolutions.com Page 14

SIDE COVER PLATE

COMP

PIVOT TUBE

U BOLT

TAM

” x ½” BOLTS & NUTS

Illustration 7

STEP 16 — SETUP OF WINDMILL COMPONENTS:

Setup of Windmill Components

1. Install the blade assembly onto the compressor crankshaft and tighten the Allen screws in

locking collar with supplied

⁄32” Allen wrench (package A) on the ﬂat sections of the crankshaft

(photo 1). Note: A little lubricant on the crankshaft can help make this step easier. If needed,

place the blade assembly on the ground and gently push down on the compressor to secure it

into the two locking collars. Attach blade hub assembly (HUB) to the crankshaft using

⁄16” x ½”

bolt (package A) into the end of the shaft (photo 2). Make sure all Allen screws and the front

mounting bolt are tight.

1 2 ... 10 11 12 13 14 15 16 17 18 19

No comments

Outdoor Water Solutions WTW0114 Installation Guide Page 15